Window Screen Replacement

When your window screen starts to develop holes big enough for the bugs to start climbing thru, it’s time for a window screen replacement.

.. Provided the frame is not damaged, replacing the screen is a fairly simple project.

Which screen to use is a personal preference. I like to use aluminum screen as it seem to last longer than nylon, but is a little harder to install. Larger hole screens are less visible but will let smaller insects sneak in.

You will need:

Tools – A small flat head screwdriver, razor knife, spline tool and a pair of needle nose pliers can be helpful.

Screen – Measure the size of the frame and add 3″ to both dimension to make installation easier.

Spline – The small rubber piece in the groove that hold the screen in place.

 

Step 1. Remove the old screen using a small flat-headed screwdriver to pry up the spline (the stiff plastic cord that is wedged into the groove of the frame) and then pull out the entire spline. It is easier to do and less likely to bend the frame if you hold the frame against a hard flat surface while you do this. When you’re done, clean the channel and the frame so that it is free of dirt and dust.

Step 2. Take a piece of the spline to the home improvement store so that you can buy replacement spline of exactly the same diameter. You’ll also need to buy a roll of window screen material and a spline roller while you’re there.

Step 3. Lay the frame with the channel side up on your work surface. Unroll the screen and cut it so it is overlapping the frame by about an inch on all sides. You can use a utility knife or scissors for this.

Step 4. Unroll the spline and cut a piece for each side of the frame, slightly longer than the channel.

Step 5. Center the screen on the frame, place the longest piece of spline on top of the screen and, starting in the corner, press the spline and screen into the channel using the spline roller. Keep pulling the screen tight as you work your way up the channel.

Step 6. Cut the spline to the exact length and push in the corners with the flat-headed screwdriver if your roller can’t reach.

Step 7. Pull the screen nice and tight to avoid wrinkles or loose screens and repeat the same process on the opposite side. When that’s done, you can do sides three and four. (Important note: if you have any wrinkles or if the screen is too tight or too loose, you can simply pull out the spline and start fresh.)

Step 8. Using a sharp blade on your utility knife, cut away the excess screen, being careful not to damage the frame or the new screen.

Thanks to myhomeimprovement.com for the great instructions.

 

One Reply to “Window Screen Replacement”

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.