Preparing Walls for Painting

Preparing walls for painting is a rather important step in the process of making your home to look fantastic. Most people would think, Hey just put some paint on the walls and we will be done! Actually, prepping your walls properly first will make your paint job a whole lot  better and last 5 times longer.

A proper prepping job actually takes longer than the painting itself. But if you want a great looking room, roll up your sleeves and lets get started.

Begin by removing as much furniture as possible from the room. Use drop cloths to cover the floor and any remaining furniture. While plastic is ideal for furniture, canvas drop cloths absorb paint, are not slippery, will not move, and can be reused.

Next, remove any pictures, mirrors, window treatments, and electrical/light switch plates. Loosen the ceiling plates of hanging light fixtures and cover the fixtures.

Washing the Walls

Because surface dirt can cause poor adhesion, use a light detergent to wash surfaces that are soiled, that are touched often, or that may have any oily residue from cooking. Take care not to leave any residue from the detergent.

Wash doors and trim, particularly where they are handled. After they are clean, wipe surfaces with a damp cloth and allow them to dry before painting.

Removing Pen, Crayon, and Water Stains

To prepare a wall for painting, use a liquid detergent to remove as much of the markings left by pens, crayons, and water stains as possible, and wipe with a clean wet cloth. For any remaining marks, spot prime the affected areas with Moore’s® QD 30® or Fresh Start® to prevent “bleeding” through the finish coat.

Dull Glossy Areas

To ensure proper adhesion, sand glossy surfaces with fine sandpaper. Be sure to remove sanding dust. Vacuum surfaces clean and wipe with a tack cloth.

Spackling

Examine floor, wall, and ceiling surfaces for nail holes, cracks, or any other surface imperfections. Use a putty knife to rake out any large plaster cracks or loose particles in your walls and ceilings.

Firmly press spackling compound into crevices with a putty knife and smooth until the compound is flush with the surface.

To fill mitered trim joinings (which are open) and door or window trim that is separated from your wall, press the compound into the crevices, and smooth it with your finger. Allow it to dry and then sand lightly.

Because patching compound shrinks when it dries, it is often necessary to apply the compound a second time after the first coat has dried.

See our article on repairing drywall:  http://www.homediyfixes.com/?p=838

When preparing your walls for painting by performing spackling work of this kind, we recommend Moorlastic® Lightweight Compound and Moorlastic Vinyl Spackling Paste.

Removing Loose Paint

Use a putty knife to remove any loose or scaling paint. When you remove paint from walls or ceilings, sand paint edges to ensure a smooth surface. This will marry the two levels of paint so the edges will not be noticed when it is re–coated.

Thanks to http://www.benjaminmoore.com/en-us/for-your-home/preparing-walls-for-painting

Now that you have properly prepped your room it is time to break out the paint and equipment and get painting.

Don’t forget drop cloths and tape to keep paint off of the places you don’t want it.

One Reply to “Preparing Walls for Painting”

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.