How to Replace an Electrical Switch.

When it comes time for replacing an electrical switch in your home, which can be done with some knowledge and a few tools, there are a few key elements that need to be followed.

Anyone with basic handyman skills will find the following article very helpful to replace a bad switch or to just update the one you have.

If a fuse blows or a circuit breaker trips every time you turn on a switch, the switch itself is probably to blame and should be replaced. There are many different types of switches, but replacement procedures for most of them are very similar. You may wish to substitute a different type for the faulty one; for example, replacing an ordinary switch with a mercury (silent) type.

Make sure the electricity is turned off before beginning to work. Either remove the fuse, or trip the breaker serving that circuit. Remove the two screws holding the cover plate, and lift off the plate. Remove the mounting screws holding the switch to the wall box, and pull out the switch.

Carefully note the wiring of the switch. It will depend on where the switch is located with regard to the rest of the circuit. Wiring for a three-way switch (where a fixture can be controlled from two separate locations) is somewhat more complex, so make sure that the new switch is wired in the same way as the faulty one. If space permits, transfer one wire at a time from the old to the new so that you get them right the first time. If you don’t have any space, label the wires with masking tape and a pen so you can remember which one is which.

Loosen the terminal screws and remove the wires from the faulty switch. Place the loops around screws on the new switch in such a way that they will be tightened when the screws are tightened. With needle nose pliers, squeeze the loops closed around the screws. Tighten the screws firmly. Place the switch in the wall box, and install mounting screws. Replace the cover plate. Restore power to the circuit by replacing the fuse or turning on the circuit breaker, now check the operation of the switch.

Back wired switches are also available, and may be used as replacements for most ordinary switches. Installation is essentially the same as that described for back wired outlets.

Dimmer switches allow you to set the lighting mood of a room, from a soft, dramatic glow to dazzling brightness, and all ranges in between, simply by turning a knob or a slider. They also conserve electricity when set at a position other than full on. Installation is similar to other switches, except that the control knob is pressed on after the switch is mounted and the place re-installed.

It’s just that easy!

Shell Busey

http://askshell.com/

Shell Busey has national recognition in Canada, with more than 50 years of home improvement industry experience under his belt; including over 25 years as a radio program host, and 118 episodes of his Home Check television program! Shell continues to deliver the how-to, what-to, where-to, why-to, when-to, and who-to of home improvement.

For more articles, tips and videos, please visit http://askshell.com/

Article Source: http://EzineArticles.com/expert/Shell_Busey/2052965

Article Source: http://EzineArticles.com/8884847

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.